Draw XXL documentation


Draw Measurements 2D.AngleSpan(...);

Draws an angle measurement. Similar to Angle(), except that it has cones on both sides of the angle span.
The function returns the measured angle, depending on the "displayAndReturn_radInsteadOfDeg" parameter in degrees or radians.

Green parameters are required. Yellow parameters are optional, but have to be supplied in order.


static float DrawMeasurements2D.AngleSpan(...);

Code snippet names: drawAngleSpan2D and drawAngleSpan2D_func.

Parameters:
Type Parameter Name Description
Vector2 from The direction from where to start the measurement.
Vector2 to The direction where to end the measurement.
Vector2 turnCenter A mounting point for "from" and "to", where in the Scene the angle measurement is drawn.
Color color The color of the angle display. The "from" and "to" vectors are colored by the static global settings DrawMeasurements.defaultColor1 and DrawMeasurements.defaultColor2.
float forceRadius
float lineWidth
string text
float custom_zPos The z position of the XY-plane inside which the thing is drawn. The default value is "infinity", which falls back to DrawBasic2D.Default_zPos_forDrawing.
bool useReflexAngleOver180deg The two vectors ("from" and "to") always span 2 angles: an acute or obtuse angle below 180°, but also the reflex angle over 180° when turning the other way round. Use this bool to specify which one to take.
bool displayAndReturn_radInsteadOfDeg Default is "false", which means: using degrees.
float coneLength The parameter can be interpreted in different ways: It can be meant as absolute length or relative to the radius. The used interpretation is decided by the global setting coneLength_interpretation_forCircledVectors. The default interpretation is "relative to radius".
bool drawBoundaryLines This draws low alpha dashed lines along the two vectors "from" and "to".
bool addTextForAlternativeAngleUnit "deg" and "rad" are two different angle units. They can be displayed both or only one of them. See also the "displayAndReturn_radInsteadOfDeg" parameter.
float durationInSec The duration in seconds how long the drawn thing stays visible. The default value of 0 means that it stays only during the current Update frame. Instead of using this parameter you can also overwrite him with a global setting so you don't always have to supply all other preceding function parameters till you reach this late parameter.
bool hiddenByNearerObjects This specifies if the drawn thing will get hidden if other geometry is in front of it or if it shines through. It is the same as the depthTest parameter of Unitys Debug.DrawLine(). Not all drawing methods support toggling this in the same way. For some methods the lines are fully hidden, for others the hidden lines shimmer through. Instead of using this parameter you can also overwrite him with a global setting so you don't always have to supply all other preceding function parameters till you reach this late parameter.